Login
Aug. 26, 2024
In most cases, the strength of a given material used to make a fastener has strength requirements or parameters described as pounds per square inch (psi) or thousands of pounds per square inch (ksi). This is helpful when analyzing what grade of material should be used for a given application, but this doesnt tell us the actual strength of that diameter of material. In order to calculate the actual strength values of a given diameter, you would use the following formulas:
If you are looking for more details, kindly visit TRM.
Note: the formulas below do not depend on the finish of the fastener.
Take the minimum yield in psi of the ASTM grade (see our Strength Requirements by Grade Chart for this value), multiplied by the stress area of the specific diameter (see our Thread Pitch Chart). This formula will give you the ultimate yield strength of that size and grade of bolt.
Example: What is the ultimate yield strength of a 3/4 diameter F Grade 36 rod?
This is the minimum requirement for F grade 36. In other words, a 3/4 diameter F grade 36 anchor rod will be able to withstand 12,024 pounds force (lbf) without yielding.
Want more information on Bolt Pull Test? Feel free to contact us.
Take the minimum tensile strength in psi of the ASTM grade, multiplied by the stress area of the diameter. This formula will give you the ultimate tensile strength of that size and grade of bolt.
Example: What is the ultimate tensile strength of a 3/4 diameter F Grade 36 rod?
This is the minimum requirement for F grade 36. In other words, a 3/4 diameter F grade 36 anchor rod will be able to withstand 19,372 pounds force (lbf) without breaking.
First, find the ultimate tensile strength using the formula above. Take that value and multiply it by 60% (0.60). It is important to understand that this value is only an estimate. Unlike tensile and yield strengths, there are no published shear strength values or requirements for ASTM specifications. The Industrial Fastener Institute (Inch Fastener Standards, 7th ed. . B-8) states that shear strength is approximately 60% of the minimum tensile strength. For more information, please see our FAQ on bolt shear strength considerations.
For more information, please visit Split Set Mining Systems.
26 0 0
Join Us
Comments
All Comments ( 0 )